Combi 8000 Series User Manual
15
Attach car seat to base.
Adjust recline using recline indicator on the side of the car seat. Line of recline indicator
MUST be in green striped zone (fig. e). If line is not in green striped zone, adjust base
(see “Base Adjustment” section), and recheck recline of car seat. Repeat until recline
indicator is in green striped zone.
MUST be in green striped zone (fig. e). If line is not in green striped zone, adjust base
(see “Base Adjustment” section), and recheck recline of car seat. Repeat until recline
indicator is in green striped zone.
If base can not be adjusted to locate the line in the green striped zone:
1. Try a different seating position.
2. Do not use this infant car seat.
2. Do not use this infant car seat.
NOTE: Vehicle must be parked on horizontal surface during this installation.
Remove car seat from base.
With hook-on connector opening facing down , position the opening of the
connector over the vehicle lower anchorage. Push down and then pull out on the
connector to lock it onto the vehicle anchorage (fig. f). You should hear a click.
connector over the vehicle lower anchorage. Push down and then pull out on the
connector to lock it onto the vehicle anchorage (fig. f). You should hear a click.
Pull on connector to be sure it is locked onto the anchorage.
Repeat for connector on opposite side.
Tighten lower anchorage belt to secure the base. Press down in center of base to depress
the vehicle cushion and pull free end of lower anchor belt to tighten belt around base
(fig. g).
the vehicle cushion and pull free end of lower anchor belt to tighten belt around base
(fig. g).
Check for secure installation. Pull base front to back and left to right
to check for secure installation (fig. h). LATCH belt MUST stay tight.
to check for secure installation (fig. h). LATCH belt MUST stay tight.
If LATCH belt does not stay tight or base can not be securely installed,
try a different LATCH location or use the vehicle’s seat belt to secure
the base.
try a different LATCH location or use the vehicle’s seat belt to secure
the base.
Attach car seat to base.
Recheck recline of car seat. Adjust if necessary (see step 9).
(fig. f)
(fig. h)
(fig. e)
8
9
10
11
12
13
14
15
2
3
1
2
3
1
(fig. g)
16
Removal Of Base Installed With LATCH:
Loosen lower anchor belt. Pressing down in center of base to reduce tension on lower
anchorage belt push adjuster slide button and loosen belt.
anchorage belt push adjuster slide button and loosen belt.
Press and hold the connector retainer spring .
Push connector in, then rotate connector , and pull out 3 to unhook from the vehicle
anchorage (fig. a). If the connector can’t be rotated, push in and lift the connector to
unhook from the vehicle anchorage.
anchorage (fig. a). If the connector can’t be rotated, push in and lift the connector to
unhook from the vehicle anchorage.
Repeat to remove connector on opposite side.
Storage Of Lower Anchorage Belt And Lower Anchor Connectors:
When not using the LATCH System, fold the anchor belt and lower anchor
connectors and place inside LATCH compartment in base (fig. b).
connectors and place inside LATCH compartment in base (fig. b).
(fig. b)
(fig. a)
1
2
3
LATCH
Compartment
1
2
3
1
2
3
Base