Quadra-Fire SAPPHIRE-D-PMH User Manual

32

Quadra-Fire  •  Sapphire  •  7055-116  Rev. D  •  6/11

Handle glass assembly with care.

•  Inspect the gasket to ensure it is undamaged.
•  Inspect the glass for cracks, chips or 

scratches.

•  Do NOT strike, slam or scratch glass.
•  Do NOT operate appliance with glass door 

removed, cracked, broken or scratched.

•  Replace glass assembly as a complete 

assembly.

  Turn the appliance OFF and let it cool down 

before replacing the inner glass door assembly.

Remove the glass door assembly by opening latches at the 
bottom front of the appliance, on both the left and right sides. 
Lift towards you and away from the appliance.

Replace with a new glass door assembly.

Lift toward you and 
away from appliance

Pull Latch Forward

NOTE:  The glass, gasketing, and frame must be replaced 
as a complete unit as supplied by the manufacturer.

Tools Required:  #2 Phillips head bit; hand drill; 11/16 in. 
wrench; and a 5/16 in. wrench.

Attach with 4 Screws

Install Snap Disc 
through the Bracket

Secure with 
5/16 in. nut

From The Kit You Will Need: Blower motor; wire harness; 
rheostat; rheostat nut; knob; screws; and 1 zip-tie.

From The Stove Component Bag You Will Need: Snap 
disc bracket and 5/16 in. nut.

Turn off gas supply (if gas is connected), and 

remove the rear shield.  Remove the blower from pack-
aging.  Place the blower under the appliance.  Attach the 
blower from the front with four screws to the blower bracket.

Install the snap disc in the bracket.  Attach the 

bracket to the fi rebox with a 5/16 in. wrench.

Connect the electrical connectors to the snap 

disc.