Sennheiser EM 300-G3 User Manual

Using the receiver

20

Using the receiver

To establish a transmission link, proceed as follows:

1. Switch the receiver on (see next section).

2. Switch the transmitter on (see the instruction manual of the trans-

mitter).
The transmission link is established and the display backlighting of the
receiver changes from red to orange.

If you cannot establish a transmission link between transmitter and
receiver:

왘

Make sure that transmitter and receiver are set to the same frequency
bank and to the same channel.

왘

Read the chapter “Synchronizing transmitters with receivers” on
page 44 and, if necessary, the chapter “If a problem occurs ...” on
page 50.

Switching the receiver on/off

To switch the receiver 

on

:

It is vital to observe the notes on frequency selection on page 44.

왘

Briefly press the 

STANDBY

 button

The receiver switches on and the “

Receiver Parameters

” stan-

dard display appears. 

ew300 G3

B.Ch: 20.24

 MHz