Ricoh 3224C Reference Guide
Administrator Setting
180
9
❒ You can edit boxes in the same
way you program them. However,
to change the SUB Code itself, you
must delete the box, and then pro-
gram a new SUB Code.
to change the SUB Code itself, you
must delete the box, and then pro-
gram a new SUB Code.
❒ If a destination in the destination
table is deleted after being regis-
tered, delivery is not performed
and the settings of the delivery
destination are also deleted. Also,
when a delivery destination is
changed, a message is sent to the
changed destination. If there is no
destination of the specified type,
you can set a certain destination to
be priority quoted. See p.164 “User
Parameters” (switch 32, bit 3).
tered, delivery is not performed
and the settings of the delivery
destination are also deleted. Also,
when a delivery destination is
changed, a message is sent to the
changed destination. If there is no
destination of the specified type,
you can set a certain destination to
be priority quoted. See p.164 “User
Parameters” (switch 32, bit 3).
Reference
p.40 “Personal Boxes”
AAAA
Press the
{{{{User Tools/Counter}}}} key.
BBBB
Press [Facsimile Features].
CCCC
Press [Administrator Tools].
DDDD
Press [Box Setting].
EEEE
Check that [Program / Change] is se-
lected.
lected.
FFFF
Select a box to program.
When programming a new box,
press [*Not Programmed].
When programming a new box,
press [*Not Programmed].
Note
❒ To change a box already pro-
grammed, press it and proceed
to step
to step
I
.
GGGG
Press [Personal Box].
HHHH
Enter a box name, and then press
[OK]
[OK]
.
Reference
“Entering Text”, General Set-
tings Guide
tings Guide
IIII
Enter a SUB Code.
Note
❒ To change the SUB Code, press
[Clear]
or the
{{{{Clear/Stop}}}} key,
and then try again. To change a
Box name, press [Box Name], and
then repeat the procedure from
step
Box name, press [Box Name], and
then repeat the procedure from
step
H
.
JJJJ
Specify the settings you require.
If you do not want to program a
password or receiver, proceed to
step
If you do not want to program a
password or receiver, proceed to
step
K
.
Programming a password
A Press [Password].
ThemisC1_Fax_EN-F_FM.book Page 180 Tuesday, January 11, 2005 4:59 PM