Ricoh cl7100 User Guide
Troubleshooting
68
4
Close Duplex Unit Cover
The cover for the duplex unit
is open.
is open.
Close the cover for the duplex
unit.
unit.
Close Finisher Front Cover
The front cover for the finisher
is open.
is open.
Close the front cover for the
finisher.
finisher.
Close Finisher Upper Cover
The finisher upper cover is
open.
open.
Close the upper cover for the
finisher.
finisher.
Close Finisher Upper Cover
The paper entrance cover for
the finisher is open.
the finisher is open.
Close the upper entrance cov-
er for the finisher.
er for the finisher.
Close Front Cover
The front cover is open.
Close the front cover for the
printer.
printer.
Close Lower Right Cover
The right cover for the paper
feed table/Large Capacity
Tray is open.
feed table/Large Capacity
Tray is open.
Close the right cover for the
paper feed table/Large Ca-
pacity Tray.
paper feed table/Large Ca-
pacity Tray.
Close Right Cover
The right cover is open.
Close the right cover.
Close Upper Left Cover
The upper left cover (the cov-
er for the fusing unit) is open.
er for the fusing unit) is open.
Close the upper left cover.
Close Upper Right Cover
The upper right cover (the
cover for the toner cartridge)
is open.
cover for the toner cartridge)
is open.
Close the upper right cover.
DHCP assigned Cannot
change
change
An attempt to change the IP
address, subnet mask or gate-
way address was made while
DHCP was set to [On].
address, subnet mask or gate-
way address was made while
DHCP was set to [On].
Make the change after setting
DHCP to [Off].
DHCP to [Off].
Driver Setting Error (Memo-
ry)
ry)
The printer identified a down-
load error. This error may oc-
cur when the installed
memory amount is less than
the driver setting.
load error. This error may oc-
cur when the installed
memory amount is less than
the driver setting.
The printer identified a down-
load error. This error may oc-
cur when the installed
memory amount is less than
the driver setting.
load error. This error may oc-
cur when the installed
memory amount is less than
the driver setting.
Duplex Cancelled
The setting of Duplex Print
has been cancelled.
has been cancelled.
(a) To print the image correct-
ly, add memory to the printer.
ly, add memory to the printer.
(b) Be sure to use the correct
paper.
paper.
Empty Punch Receptacle
The Punch Chips container is
full of punch chips.
full of punch chips.
Empty the punch waste box.
If the message appears the
punch waste box is not full, re-
move the Punch-hole chips on
the top of the punch waste
box.
punch waste box is not full, re-
move the Punch-hole chips on
the top of the punch waste
box.
Energy Save Mode
In Energy Save Mode level 2.
No action required.
Messages
Description
Recommended Action