Intermec 6200 Reference Guide

R

The following entries match the orientation of the PEN*KEY digitizer to the

screen display.  The pen driver must take into account any rotation of the screen

display, as well as additional rotational offset of the digitizer relative to the

display.  The calibration values given in the preceding section are swapped and

flipped to match the final user orientation of the digitizer.

Specifies the orientation of the display.  0 is the default hardware orientation.

1ć3 indicate successive 90Ćdegree clockwise rotations.  Must be located in the



[Display Driver]

" section of SYSTEM.INI.  

Valid values for degrees of rotation:

0 = 0

1 = 90 (default)

2 = 180

3 = 270

Specifies additional rotation of the pen digitizer orientation relative to the

display, which may already be rotated by the preceding DisplayOrientation

value.  The orientation of the pen relative to the default hardware display

orientation is the DisplayOrientation value (preceding) added to the

PenOrientation value.  Should not need to be specified for the PEN*KEY HHC.
Valid values for degrees of  rotation:

0 = 0

1 = 90

2 = 180 (default)

3 = 270

When nonzero, the XĆaxis values are inverted.  Should not need to be specified

for the PEN*KEY HHC.
Valid values:

0, 1

Default:

0

Valid values:

0 to 640

Default:

320

PENALIGN.EXE uses this value, if set, to place the targets for calibration.  If

not set, PENALIGN uses the values from the display driver.  Use this entry to

set the value if you are running on the 6300 Computer with a display physically

smaller than a standard display driver that reports 640X480.

DisplayRows (Description is same for DisplayColumns entry)

Valid values:

0 to 480

Default:

480