Intermec cn2a Supplementary Manual
CN2 Battery Instructions
CN2 Battery Instructions
*074754-004*
P/N 074754-004
The CN2 battery (Model 074201) is a 2150 mAh lithium-ion battery
designed for use in CN2 mobile computers.
designed for use in CN2 mobile computers.
Charging the Battery
You need to fully charge the battery before using it in your CN2.
Batteries can be charged after a partial discharge without aff ecting
the original battery capacity. A fully discharged battery charges
in approximately 4 hours. Use the next table to understand the
charging methods available for each CN2 model.
Batteries can be charged after a partial discharge without aff ecting
the original battery capacity. A fully discharged battery charges
in approximately 4 hours. Use the next table to understand the
charging methods available for each CN2 model.
CN2 Battery Charging Methods
Charging Accessory
Model or P/N
Supports
CN2 Single USB Client Dock
Model AD7
CN2A, CN2B
CN2 Modem Dock
Model AD8
CN2A, CN2B
CN2 Communications Dock
Model 074248
CN2G
CN2A Ethernet Dock
Model AD13
CN2A
CN2 Quad Battery Charger
Model AC13
CN2A, CN2B
CN2 Vehicle Dock
Model AV5
CN2A, CN2B
CN2 Car Adapter
Model AE6
CN2A, CN2B
CN2 AC Wall Adapter
P/N 074246-003
CN2A, CN2B
For more information about CN2 charging accessories, see the
instructions that ship with the accessory.
instructions that ship with the accessory.
CN2 Batter
y Instructions
Replacing the Batter
y
1
Tu
rn off the CN2 b
y pr
essing and holding the Po
we
r key f
or
about 2 seconds until the CN2 turns off
.
Push do
wn on the batter
y door latch, and pull up on the
batter
y door.
Diff er
ent CN2 Models:
T
hese illustrations show a CN2A
mobile comput
er. Y
our CN2 may be slightly diff
erent.
For example
, you ma
y hav
e a t
ethered st
ylus.
2
Inser
t the stylus bet
ween the batt
ery and the CN2 case
, and fi rmly
press straight do
wn until the batter
y is released
.
Remov
e the batt
ery
.
Align the batt
ery c
ontac
ts and insert the new batt
ery in the batt
ery
compar
tment. Press do
wn on the batter
y until it clicks into
place
.
Install the batt
ery door
.
When the battery reaches the end of its useful life, the
spent battery should be disposed of by a qualifi ed
recycler or hazardous materials handler. Do not mix
this battery with the solid waste stream. Contact your
Intermec Technologies Service Center for recycling or
disposal information.
spent battery should be disposed of by a qualifi ed
recycler or hazardous materials handler. Do not mix
this battery with the solid waste stream. Contact your
Intermec Technologies Service Center for recycling or
disposal information.
Note: In the U.S.A., the EPA does not consider spent
Li-ion batteries as hazardous waste.
Li-ion batteries as hazardous waste.
Disposal Instructions
Batter
y
4
5
6
3
Worldwide Headquarters
6001 36th Avenue West
Everett, Washington 98203
U.S.A.
6001 36th Avenue West
Everett, Washington 98203
U.S.A.
tel 425.348.2600
fax 425.355.9551
www.intermec.com
©
2007 Intermec Technologies
Corporation. All rights reserved.