Intermec 2430 User Guide
Chapter 6—Configuration Command Reference
132
Trakker Antares 2400 Family System Manual
3
Scan this bar code:
Exit Accumulate Mode
*-/*
*-/*
Acknowledgement Delay Upper Limit
Terminals: 2415, 2425, 2435, 2455, 2475, and 2485/6.
Description: When the terminal sends a message to the Intermec Gateway or DCS 30X,
the terminal waits to receive a response acknowledging the message. If no
response is received within the Acknowledgement Delay Lower Limit
time, the terminal sends the message again at the time interval set for the
lower limit. The terminal will continue to send the data at increasingly
longer intervals until it reaches the Acknowledgement Delay Upper Limit
time. The terminal continues sending the message at the time interval set
for the upper limit until a response is received or a timeout error occurs.
response is received within the Acknowledgement Delay Lower Limit
time, the terminal sends the message again at the time interval set for the
lower limit. The terminal will continue to send the data at increasingly
longer intervals until it reaches the Acknowledgement Delay Upper Limit
time. The terminal continues sending the message at the time interval set
for the upper limit until a response is received or a timeout error occurs.
Syntax: NUdata
Acceptable values for data are any number from 2000 to 60000 ms.
Default: 5000
ms
Menu System: Main Menu > Configuration Menu > Communications Menu > Advanced
Network
Bar Codes: To set the default acknowledgement delay upper limit, scan this bar code:
Default Acknowledgement Delay Upper Limit
*$+NU5000*
*$+NU5000*
Or: To set the acknowledgement delay upper limit:
1
Scan this bar code:
Enter Accumulate Mode / Set Acknowledgement Delay Upper Limit
*+/$+NU*
*+/$+NU*
2
Scan a numeric value for data from these bar codes:
*0*
*1*
*0*
*1*
*2*
*3*
*2*
*3*