Intermec 2430 User Guide

High Decode Security 

*$+CS2* 

*$+CS2* 

 

Terminals:  2415, 2425, 2435, 2455, 2461, 2475, 2480/1 with the Ethernet option, 

and 2485/6 using the TCP/IP or UDP Plus network. 

 

Description:  Defines the IP address assigned to the default router in your RF or 

Ethernet network. The router provides a software and hardware 
connection between two or more subnetworks that permits traffic to be 
routed from one subnetwork to another on the basis of the intended 
destinations of that traffic. 

When the Intermec Gateway, DCS 30X, or host (TCP/IP network) is on a 
different subnetwork than the terminal, you need to set the IP address 
assigned to the default router. The terminal uses the router address to send 
packets across the network to the Intermec Gateway, DCS 30X, controller, 
or host. The default of 0.0.0.0 means there is no default router. 

 

Syntax: NXn.n.n.n 

where each n address segment is a number from 0 to 255. The default 
router address field consists of four separate numbers, each separated by a 
period. 

 

Note: The RF or Ethernet network cannot be activated if the first address 
segment in the IP address is set to 0, 127, or a number greater than 223. 

 

Default: 0.0.0.0 

 

Menu System:  Main Menu > Configuration Menu > Communications Menu > Advanced 

Network 

 

Bar Codes:  To set the default value for the default router, scan this bar code: 

No Default Router 

*$+NX0.0.0.0* 

*$+NX0.0.0.0* 

 

Or:  To set the default router address: 

Scan this bar code: 

  Enter Accumulate Mode / Set Default Router 

 

*+/$+NX* 

 *+/$+NX*