Intermec 2430 User Guide

 

Terminals:  2415, 2425, 2435, 2455, 2461, 2475, 2480/1 with the Ethernet option, 

and 2485/6 using the TCP/IP or UDP Plus network. 

 

Description:  When DHCP (Dynamic Host Configuration Protocol) is enabled on the 

terminal, the terminal receives its IP address from the DHCP server. The 
IP address it receives may be permanent or leased.  

Permanent 

The terminal uses the assigned IP address until you reboot the terminal. 

Leased 

The terminal uses the assigned IP for leased amount of time that is 
specified by the server. The terminal must renew the lease before it expires 
to maintain communication. 

 

Note: The leased DHCP server setting is not supported on the 2461. 

 

 

The DHCP server assigns the following network parameters: 

•  Terminal IP Address 

•  Subnet Mask (optional) 

•  Default Router (optional) 

The Terminal IP Address field displays 0.0.0.0 to indicate that DHCP is 
enabled, however, the terminal uses the IP address that it receives from the 
DHCP server. To see the IP address that the DHCP server assigns to the 
terminal, from the Main Menu, choose About TRAKKER 2400. 

The parameters assigned by the DHCP server are not permanently stored 
on the terminal. These parameters are reset each time you reboot the 
terminal. 

 

Syntax: Not 

supported. 

 

Default: Enabled 

 

Menu System:  To use the menu system and enable the terminal to use DHCP: 

From the Main Menu, choose Configuration Menu > 
Communications Menu > Primary Network. 

Set the Terminal IP Address. 

•  To enable DHCP, set the Terminal IP Address to 0.0.0.0. 

•  To disable DHCP, set the Terminal IP Address to a value other than 

0.0.0.0.