Intermec 2430 User Guide
Chapter 6—Configuration Command Reference
Trakker Antares 2400 Family System Manual
175
3
Set the Network Activate command to enabled.
4
Exit the menu system and save all changes.
Bar Codes: To use bar codes and enable the terminal to use DHCP:
1
Set the Terminal IP Address.
• To enable DHCP, set the Terminal IP Address to the default value of
0.0.0.0.
Default Terminal IP Address
*$+ND0.0.0.0*
*$+ND0.0.0.0*
• To disable DHCP, set the Terminal IP Address to a value other than
0.0.0.0. For help, see “Terminal IP Address” on page 252.
2
Set a controller IP address or a host IP address. For help, see “Controller
IP Address” on page 166 or “Host IP Address” on page 192.
IP Address” on page 166 or “Host IP Address” on page 192.
3
Set the Network Activate command to enabled.
Enable RF or Ethernet Network
*$+NA1*
*$+NA1*
Display Backlight Timeout
Terminals: 241X, 242X, and 243X.
Description: Defines the amount of time the backlight stays on as long as there is no
keypad or scanning activity on the terminal. The backlight timeout resets
each time there is activity. This setting significantly affects the terminal’s
battery life. If you set a longer backlight timeout value, you will use the
power in the main battery pack at a faster rate.
each time there is activity. This setting significantly affects the terminal’s
battery life. If you set a longer backlight timeout value, you will use the
power in the main battery pack at a faster rate.
Syntax: DFdata
Acceptable values for data are:
00 Disabled
01-60 Timeout
01-60 Timeout
in
seconds
Default: 10
seconds
Menu System: Main Menu > Configuration Menu > Terminal Menu > Display
Bar Codes: To disable the backlight timeout, scan this bar code:
Disable Backlight Timeout
*$+DF00*
*$+DF00*