Intermec 2430 User Guide

 

Terminals:  2415, 2425, 2435, 2455, 2461, 2475, 2480/1 with the Ethernet option, 

and 2485/6 using the UDP Plus network. 

 

Description:  If your Intermec Gateway or DCS 30X is operating as a DHCP (Dynamic 

Host Configuration Protocol) client, its IP address will change each time it 
is turned on. When the DHCP controller command is enabled on the 
terminal, the terminal can identify and use the IP address of the Intermec 
Gateway or DCS 30X. The terminal IP address is not changed by this 
command. To use DHCP to change the terminal IP address, see the next 
section, “DHCP (Terminal).” 

If Controller IP Address is set to 0.0.0.0, controller DHCP is used to 
obtain a non-zero controller IP address, even if DHCP (Controller) is not 
enabled. For help, see Controller IP Address on page 166. 

To see the DHCP-assigned controller IP address, from the Main Menu, 
choose About TRAKKER 2400. 

Important: After you enable or disable DHCP, you must save the 
configuration in flash memory for the change to take effect. 

 

Syntax: NIdata 

Acceptable values for data are: 

0 

Disable DHCP (Controller) 

1 

Enable DHCP (Controller) 

 

Default: Disabled 

 

Menu System: Not 

supported 

 

Bar Codes:  To set DHCP (Controller): 

Scan one of these bar codes to disable or enable DHCP (Controller): 

  Disable DHCP (Controller) 

Enable DHCP (Controller) 

 

*$+NI0* 

*$+NI1* 

 *$+NI0* 

*$+NI1* 

To save the changes in flash memory, scan this bar code: 

  Save Configuration in Flash Memory 

 

*.+1* 

 *.+1*