Intermec 2430 User Guide
Chapter 6—Configuration Command Reference
Trakker Antares 2400 Family System Manual
219
Enable Poll (Set to FS) for COM3
*/D/KYR3/N%B*
*$+YR3
.
%B*
Enable Poll (Set to FS) for COM4
*/D/KYR4/N%B*
*$+YR4
.
%B*
Note: FS is encoded as %B in a Code 39 bar code label.
Postamble
Terminals: All Trakker Antares terminals.
Description: Sets the postamble that is appended to any data you scan with the
terminal. Common postambles include cursor controls such as a tab or a
carriage return line feed.
carriage return line feed.
You can set the postamble to use characters from the extended ASCII
character set such as the Field Exit code for 5250 TE. However, you
cannot scan in extended ASCII characters in the Postamble command.
You must use the TRAKKER Antares 2400 Menu System. For help, see
“Entering ASCII Control Characters” in the configuration chapter in your
user’s manual.
character set such as the Field Exit code for 5250 TE. However, you
cannot scan in extended ASCII characters in the Postamble command.
You must use the TRAKKER Antares 2400 Menu System. For help, see
“Entering ASCII Control Characters” in the configuration chapter in your
user’s manual.
Syntax: AEdata
Acceptable values for data are up to 25 ASCII characters. If you are
entering quotation marks as data or grouping configuration commands,
you must enclose the data within quotation marks (see the example).
entering quotation marks as data or grouping configuration commands,
you must enclose the data within quotation marks (see the example).
Note: To scan a bar code label that includes quotes, you must configure
the terminal to use Code 39 in Full ASCII mode. For help, see “Code 39”
on page 146.
the terminal to use Code 39 in Full ASCII mode. For help, see “Code 39”
on page 146.
Default: No characters (Disabled)
Menu System: Main Menu > Configuration Menu > Terminal Menu >
Preamble/Postamble
Bar Codes: To disable the postamble, scan this bar code:
Disable Postamble
*$+AE*
*$+AE*