Intermec 2430 User Guide
Chapter 6—Configuration Command Reference
Trakker Antares 2400 Family System Manual
221
Syntax: LHdata
Acceptable values for data are:
0 Disabled
1 Enhanced
2 Standard
1 Enhanced
2 Standard
Default: Enhanced
Menu System: Main Menu > Configuration Menu > Communications Menu > Radio
Bar Codes: Scan one of these bar codes:
Enable Enhanced
Disable Power Management
Power Management
*$+LH0*
*$+LH1*
*$+LH0* *$+LH1*
Enable Standard Power Management
Enable Standard Power Management
*$+LH2*
*$+LH2*
Preamble
Terminals: All Trakker Antares terminals.
Description: Sets the preamble that precedes any data you scan with the terminal.
Common preambles include a data location number or an operator
number.
number.
You can set the preamble to use characters from the extended ASCII
character set. However, you cannot scan in extended ASCII characters in
the Preamble command. You must use the TRAKKER Antares 2400
Menu System. For help, see “Entering ASCII Control Characters” in the
configuration chapter in your user’s manual.
character set. However, you cannot scan in extended ASCII characters in
the Preamble command. You must use the TRAKKER Antares 2400
Menu System. For help, see “Entering ASCII Control Characters” in the
configuration chapter in your user’s manual.
Syntax: ADdata
Acceptable values for data are up to 25 ASCII characters. If you are
entering quotation marks as data or grouping configuration commands,
you need to enclose the data within quotation marks (see the example).
entering quotation marks as data or grouping configuration commands,
you need to enclose the data within quotation marks (see the example).
Note: To scan a bar code label that includes quotes, you must configure
the terminal to use Code 39 in Full ASCII mode. For help, see “Code 39”
on page 146.
the terminal to use Code 39 in Full ASCII mode. For help, see “Code 39”
on page 146.
Default: No characters (Disabled)
Menu System: Main Menu > Configuration Menu > Terminal Menu >
Preamble/Postamble