Intermec 2430 User Guide

 

Bar Codes:  Scan one of these bar codes: 

Scanner Redundancy None 

Scanner Redundancy Normal 

*$+SR0* 

*$+SR1* 

*$+SR0* *$+SR1* 
Scanner Redundancy High 

*$+SR2* 

*$+SR2* 

 

Terminals:  All Trakker Antares terminals. 

 

Description:  Identifies the type of scanner you have connected to the terminal. The 

terminal can optimize the scanning performance by using the scanner you 
define in this command. When you select a specific scanner, other 
scanners may not function properly. Your terminal may not work if you 
connect an incompatible scanner or if you select an incorrect option for 
your input device.  

For 241X, 242X, and 243X terminals, you can also use this command to 
configure the spotting beam when you have a long range or high visibility 
scanner on the terminal. There are three options: no aim, short aim, and 
long aim. 

No aim 

The spotting beam is turned off. When you press the Scan button, the laser 
scanner starts scanning immediately. 

Short aim 

The spotting beam appears for 400 ms to help you aim the laser scanner 
before it starts scanning. 

Long aim 

The spotting beam appears for 1 second to help you aim the laser scanner 
before it starts scanning. 

 

 

For 242X terminals, the Scanner Selection configuration command is only 
used when a module for cabled scanners, long range scan module, or a 
high visibility scan module is installed on the terminal. 

 

Note: For 243X terminals, you must define this command and select the 
tethered input device that is connected to the terminal. If this command is 
not defined for the appropriate input device, the scanner trigger on the 
input device may activate the integrated scanner on the terminal.