Intermec 2430 Quick Setup Guide

C d 39 nuggetfont

 

243XQ156.eps

SERIAL

PORT

[COM1]

Protocol:

Configurable

Baud

Rate:

19200

Parity:

Even

Data

Bits:

7

Stop

Bits:

1

`

more

 

Before you can use the 2435, you need to install and configure 
the host and access points. You may also need to install and 
configure the Intermec Gateway or DCS 30X. Depending on 
your network protocol, the 2435 can communicate with a host 
computer either through access points and the Intermec 
Gateway or DCS 30X (UDP Plus or WTP network) or directly 
through the access points (TCP/IP network).  

Press l t 2 4 8 , l x 2 4 8 , or the 
orange > key and then * 2 4 8 to access the TRAKKER 
Antares 2400 Menu System. Choose Configuration Menu, 
Communications Menu, Primary Network or Advanced 
Network. You need to obtain most of these settings from your 
network administrator.  

 

Note: If you are using the WTP network, you only 
need to configure the Primary Network parameters. 

Make sure that 2.4 GHz RF (OpenAir radio) or 802.11 DS 
(802.11b radio) appears in the Activate field. 

If you are using the WTP network, you only need to 
configure the Activate field. 

(UDP Plus) In the Controller IP Address field, enter the IP 
address of the Intermec Gateway or DCS 30X. The IP