Intermec 2430 Quick Setup Guide
C d 39 nuggetfont
Trakker Antares 243X Handheld Terminal Quick Start Guide
15
2
Select Set-up Parms and press v. A password prompt
appears.
appears.
3
Type C R 5 2 4 0 1 and press v.
4
Select Protocol Opts, Data Stream, and then select the
appropriate TE 2000 configuration.
appropriate TE 2000 configuration.
5
Save your changes by selecting Exit Menus from the
TE 2000 main menu. Press Y, and type C R 5
2 4 0 1 at the Enter Password prompt.
TE 2000 main menu. Press Y, and type C R 5
2 4 0 1 at the Enter Password prompt.
For information about using TE 2000 terminal emulation, see
the appropriate TE 2000 guide listed on page 19.
the appropriate TE 2000 guide listed on page 19.
Using the Keypad
Characters, symbols, and functions are printed in four places on
or above the keys. The keypad overlays are also color-coded to
make it easier to remember key combinations.
or above the keys. The keypad overlays are also color-coded to
make it easier to remember key combinations.
Using the Keypad
Position on the Keypad
Color
To Type the Character
Printed on the key
Press the key.
Left side above the key
Orange
Press the l key, and then
press the key.
press the key.
Centered above the key
Pink
Press the w key, and then
press the key.
press the key.
Right side above the key
Blue
Press the r key, and then
press the key.
press the key.
You can also use the arrow keys to move around an application
screen. To go up or down the screen, press u or d. To go left or
right, press a or b.
screen. To go up or down the screen, press u or d. To go left or
right, press a or b.
Learning About the Bar Code Symbologies
Although the 243X can decode many types of bar code
symbologies, only three symbologies are enabled when you
unpack the terminal: Code 39, Code 128, PDF417 (PDF417
tethered scanner only), and UPC/EAN. You need to configure
the terminal to decode the bar code symbology used in your bar
symbologies, only three symbologies are enabled when you
unpack the terminal: Code 39, Code 128, PDF417 (PDF417
tethered scanner only), and UPC/EAN. You need to configure
the terminal to decode the bar code symbology used in your bar