Intermec 2480 Quick Setup Guide
nugget
d 39
14
Trakker Antares 248X Stationary Terminal Quick Start Guide
248XG.035
To power
supply
supply
12V power
supply connector
supply connector
Badge
scanner
connector
scanner
connector
External
scanner
connector
scanner
connector
12V power
supply plug
supply plug
Scissors
seal
seal
Cable
restraint
restraint
Cable
restraint bar
restraint bar
4
Use a Phillips screwdriver to loosen one of the screws on the cable
restraint. Route the power supply cable under the cable restraint.
Tighten the screw to secure the cable.
restraint. Route the power supply cable under the cable restraint.
Tighten the screw to secure the cable.
5
Route all the cables under the cable restraint bar and through the
scissors seal.
scissors seal.
6
Leave the back panel off and continue with the instructions to connect
other network devices.
other network devices.
Charging the Backup Battery
The backup battery backs up all memory and the real-time clock in case of
a power failure. The backup battery is shipped inside the terminal, but
may not be fully charged. You need to fully charge the backup battery after
you install the terminal.
a power failure. The backup battery is shipped inside the terminal, but
may not be fully charged. You need to fully charge the backup battery after
you install the terminal.
To charge the backup battery
1
Make sure the power supply is connected to the terminal and a powered
electrical outlet.
electrical outlet.
2
Let the power supply charge the backup battery for 24 hours to fully
charge the backup battery.
charge the backup battery.