Intermec 2480 Quick Setup Guide
nugget
d 39
Trakker Antares 248X Stationary Terminal Quick Start Guide
13
Connecting Power and Input Devices
You connect power and input devices through the rear enclosure of the
Trakker Antares 248X terminal.
Trakker Antares 248X terminal.
To connect the power supply and input devices
1
Use a Phillips screwdriver to remove the six screws on the back panel.
248XG.005
Back panel
Screw
(6 places)
(6 places)
2
Remove the back panel and place it on a clean surface.
3
Connect the power supply and input devices to the back of the
terminal.
terminal.
• Connect the power supply plug to the 12V power supply connector.
Next, connect the power cord from the power supply to a powered
electrical outlet.
electrical outlet.
• Connect the badge scanner 6-pin connector to the badge scanner
connector.
• Connect the Stewart 10-pin connector from the input device to the
external scanner connector.