Intermec 1470 User Guide
Programming the 147X
3-29
3
Aimer Interval (continued)
Every “X” Reads (see Note)
Note:
A one to three digit number and Save are required after reading this programming
bar code. See the “General Programming Chart” in Appendix B.
AutoTrigger
Two AutoTrigger Modes are available: Scan Stand and Presentation Mode.
When an imager is in Scan Stand mode, the LED shines at the bar code on the base of
the stand, which tells it to remain idle. To set Scan Stand mode, see “Scan Stand” later
in this section. When a different code is presented, the imager is triggered to read the
new code.
the stand, which tells it to remain idle. To set Scan Stand mode, see “Scan Stand” later
in this section. When a different code is presented, the imager is triggered to read the
new code.
Presentation mode is for those applications where a scan stand will not work, i.e., when
large packages must be scanned. To program the device for presentation mode, see
“Presentation Mode” later in this section.
large packages must be scanned. To program the device for presentation mode, see
“Presentation Mode” later in this section.
Scan Stand
This selection programs the imager to work in a Scan Stand.
In the Imager tab of Visual Menu, choose Scan Stand On. Click the Write Settings to
Device button (
) to send the new setting to the imager.