Xerox 4112 User Guide

Xerox 4112/4127 Copier/Printer System Administration Guide

9-3

9. Troubleshooting

automatically switches to Disable if the machine has 

insufficient memory. If this happens, either set an unused port 

to Disable, or adjust the assigned memory size.

•

Adjust the receiving buffer 

 size according to 

usage. When the receiving buffer 

 size is smaller 

than the transmitted data, the machine may not be able to 

receive the data.

•

Take maximum care with the IP address settings. IP 

addresses are managed throughout the system as a whole. 

The configuration should be performed only after consulting 

with your network administrator.

•

When performing network settings (IP address, etc.) on a host 

under the NIS (Network Information Service) management, 

consult with the NIS administrator.

Check the following points when switching off the machine:
•

When the 

 is set to 

.

All print data spooled within the machine memory, including 

the data which is being printed is erased. The print data will 

not be found when the machine is powered on again.
However, if the power was switched off immediately after a 

computer instructed a print job, the job may remain on the 

computer. In this case, the stored data on the computer will be 

printed out in order before any later instructions when the 

machine is powered back on.

•

When the 

 is set to 

.

All print data spooled in the machine hard disk, including the 

data which is being printed is preserved. In this case, the 

stored data on the machine hard disk will be printed out in 

order before any later instructions when the machine is 

powered back on.

•

When the 

 is set to 

.

All print data spooled in the machine receiving buffer, including 

the data which is being printed is erased. The print data will 

not be found when the machine is powered on again.
However, if the power was switched off immediately after a 

computer instructed a print job, the job may remain on the 

computer. In this case, the stored data on the computer will be 

printed out in order before any later instructions when the 

machine is powered back on.