Xerox 550 User Guide
2
Setting Up
2-6
Phaser CopyStation
Connecting the SCSI cable
The method you use for connecting the CopyStation depends on whether
you also wish to have a disk drive connected to your printer.
you also wish to have a disk drive connected to your printer.
Connecting the CopyStation directly to the printer (with no disk drive)
Caution
To avoid damage to the CopyStation and the printer, make sure
that their power is switched
that their power is switched
off
during this procedure.
1.
Connect the CopyStation’s SCSI cable to the printer’s SCSI port.
Press the plug firmly onto the printer’s SCSI connector: the
catches at the plug’s sides clip onto the connector to fasten it
securely.
Press the plug firmly onto the printer’s SCSI connector: the
catches at the plug’s sides clip onto the connector to fasten it
securely.
2.
Connect the free end of the cable to the CopyStation’s SCSI port.
a.
Press the cable plug firmly onto the rear-panel connector.
b.
Secure the cable to the CopyStation’s rear panel by pressing
the connector’s wire latches against the sides of the plug.
the connector’s wire latches against the sides of the plug.
3.
If you are not connecting a disk drive to your printer, skip ahead
to the topic “Connecting to power.”
to the topic “Connecting to power.”
1
2b
2a
9020-14