Xerox 6110MFP User Manual

.9   

<Loading originals and print media>

Squeeze the manual feeder paper width guides and adjust them to 
the width of the paper. Do not force too much, or the paper will be 
bent, which will result in a paper jam or skew.

After loading paper, set the paper type and size for the manual 
feeder. See page 5.9 for copying and faxing or the Software 
Section

 for PC-printing.

Tips on using the manual feeder
• Load only one size of print media at a time in the manual feeder.

When you print out many pieces of paper at once, tray 1 use is 
recommended.

• To prevent paper jams, do not add paper when there is still paper in 

the manual feeder. This also applies to other types of print media.

• Print media should be loaded face up with the top edge going into the 

manual feeder first and be placed in the center of the tray.

• Always load only the print media specified in page 5.2 to avoid paper 

jams and print quality problems.

• Flatten any curl on postcards, envelopes, and labels before loading 

them into the manual feeder.

• The settings made from the printer driver override the 

settings on the control panel.

• If you want to print several pages with the manual feeder, 

wait the machine complete the printing one page, then 
place a paper on the manual feeder. Otherwise it may 
cause the paper jam.

After loading paper in the paper tray, you need to set the paper size and 
type using the control panel buttons. These settings will apply to Copy 
and Fax modes. For PC-printing, you need to select the paper size and 
type in the application program you use on your PC.

Press Menu until System Setup appears on the bottom line of the 
display and press Enter.

Press the Scroll buttons until Paper Setup appears and press 
Enter

.

Press Enter when Paper Size appears.

Press the Scroll buttons until the paper tray you want appears and 
press Enter. 

Press the Scroll buttons until the paper size you are using appears 
and press Enter. 

Press Exit to return to the upper level.

Press the Scroll buttons until Paper Type appears and press 
Enter

.

Press the Scroll buttons until the paper type you are using appears 
and press Enter. 

Press Stop/Clear to return to Standby mode.