Gestetner c7006dw Operating Guide
Troubleshooting
78
4
B Remove the ozone filter from
inside the ventilator hole cover.
C Install a new ozone filter on
the ventilator hole cover.
D Return the ventilator hole cov-
er its original position.
D
Replace the two ozone filters in-
side the printer.
A Push the front cover release but-
side the printer.
A Push the front cover release but-
ton and open the front cover.
B Grasping the ozone filter by its
tab, remove it from the printer.
C Insert a new ozone filter into
the printer.
Slide the filter into the stopper.
Two small thin plastic tabs of
the top of the filter should click
into place.
Slide the filter into the stopper.
Two small thin plastic tabs of
the top of the filter should click
into place.
D Close the front cover.
Confirm that the front cover
close properly.
close properly.
E
Turn on the printer’s power
switch.
switch.
Note
❒ After replace the fuser oil bottle,
it takes a few minutes until the
message clears.
message clears.
Replacing the Waste Toner
Bottle
Bottle
Replace the waste toner bottle when-
ever the following messages appear
on the panel display.
ever the following messages appear
on the panel display.
IPDL-C
Waste T Full
Waste Toner is
Full
TFWX070E
TFWX080E
TFWX310E
TFWX320E