Gestetner dsc332 Operating Guide
Appendix
106
9
*1
IP address
SLP
Use the "slp" command to configure
SLP settings.
You can search the NetWare server
using SLP in the PureIP environment
of NetWare5/5.1, 6. Use the "slp"
command to configure the value of
TTL used by the SLP multi-cast-pack-
et.
SLP settings.
You can search the NetWare server
using SLP in the PureIP environment
of NetWare5/5.1, 6. Use the "slp"
command to configure the value of
TTL used by the SLP multi-cast-pack-
et.
Note
❒ The default value of TTL is “1”. A
search is executed only within a lo-
cal segment. If the router does not
support multi-cast, the settings are
not available even if the TTL value
is increased.
cal segment. If the router does not
support multi-cast, the settings are
not available even if the TTL value
is increased.
❒ The acceptable TTL value is 1 - 255.
msh> slp ttl {1 - 255}
SPRINT
Use the "sprint" command to view
and configure SCSI print (SBP-2) on
IEEE 1394.
and configure SCSI print (SBP-2) on
IEEE 1394.
Limitation
❒ You can use this function when the
optional IEEE 1394 interface board
is installed.
is installed.
❖
❖
❖
❖ Viewing settings
The following command displays
the current IEEE 1394 (SCSI print)
settings:
the current IEEE 1394 (SCSI print)
settings:
msh> sprint
❖
❖
❖
❖ Bidirectional configuration for IEEE
1394 (SCSI print)
msh> sprint bidi {on | off}
Use this setting to select whether
IEEE 1394 (SCSI print) is bidirectional
or not. The default is “on”.
IEEE 1394 (SCSI print) is bidirectional
or not. The default is “on”.
Setting IEEE 802.11b
Use the "wiconfig" command to con-
figure IEEE 802.11b settings.
figure IEEE 802.11b settings.
Limitation
❒ You can make settings when in-
stalling the optional IEEE 802.11b
interface unit.
interface unit.
❖
❖
❖
❖ View settings
The following command displays
the current IEEE 802.11b settings.
the current IEEE 802.11b settings.
msh> wiconfig
The following command displays
the IEEE 802.11b card information.
The following command displays
the IEEE 802.11b card information.
msh> wiconfig cardinfo
Note
❒ If the IEEE 802.11b interface is
not working correctly, the op-
tional IEEE 802.11b interface unit
information is not displayed.
tional IEEE 802.11b interface unit
information is not displayed.
Displays only route informa-
tion corresponding to a spec-
ified destination. When the
destination is unspecified, all
routing information is dis-
played.
tion corresponding to a spec-
ified destination. When the
destination is unspecified, all
routing information is dis-
played.
route active
{host | net}
destination
on/off
{host | net}
destination
on/off
You can turn the specified
destination on or off. Host be-
comes the default.
destination on or off. Host be-
comes the default.
You can set the default gate-
way address.
way address.
route flush
Deletes all routing informa-
tion.
tion.
Commands
Topics of setting