Sony DPT-S1 Manual

77

Tip
 Replace the stylus tip periodically to prevent 

damage to the Digital Paper device and maintain 

smooth operation.

 If you have used the supplied replacement tips, 

new stylus tips are sold separately.

The Digital Paper device will not turn on.
 The device cannot be operated if connected to your 

computer and set to transfer data. Use the Safely 

Remove Hardware function of your computer, and 
then disconnect the USB cable from the device.

 Moisture condensation may have occurred. Wait for 

a few hours, then turn it on.

 If the battery is completely depleted, you may not 

be able to turn on the device.

Charge the device by connecting it to the supplied 

AC adapter or your computer via the supplied USB 
cable, and the device will turn on.

 If the device still does not turn on, press the  

(Power) button.

 If the Charge indicator blinks red 3 times upon 

pressing the 

 (Power) button, it shows that the 

device battery is completely depleted.

To charge the device, insert the supplied USB cable 
into the micro USB port and connect it to the 

supplied AC adapter, or connect the device to a 

computer using the supplied USB cable.

 If the battery is completely depleted, it may take up 

to 5 minutes for the device to turn on.

The Digital Paper device automatically enters sleep 
mode or turns off.
 To conserve the battery’s charge, the device 

includes automatic power saving modes. The 

device will enter sleep mode after 1 hour of 
inactivity. After 3 days* in sleep mode, it will shut 

down/power off automatically.

* If the battery’s charge is low, the device may 

automatically turn off within 3 days.

Cannot charge the Digital Paper device.
 If you use equipment other than the supplied USB 

cable or AC adapter to charge the device, it may not 
charge correctly. We do not guarantee the 

performance and safety of the device.

To charge the device, use only the supplied USB 
cable, or the supplied AC adapter (page 8).

 If you are charging from the USB port on your 

computer, make sure that the device is connected 
directly to the USB port with the supplied USB cable. 

If you connect the computer using a USB hub, we do 

not guarantee the performance of the device.

 The battery has not been given enough time to fully 

charge. Charge the device until the 

 icon changes 

to the 

 icon. (The charge icon does not indicate 

the remaining battery power while charging.)

 If you are charging from a USB port on your 

computer, your computer must be turned on to 

charge the device. The device will not be charged if 

your computer enters sleep mode, standby mode 
or hibernation. Keep your computer turned on with 

a stable and continuous power supply while 

charging the device.

 When you set [Screen Transfer] to On and charge 

the device by connecting the device to your 

computer via USB cable, check if the dedicated 
driver is installed onto the computer (page 57).

The device cannot be charged through the 

computer if the installation of the driver is not 
completed.

 If your computer enters sleep mode while the 

device is connected and charging, the device 

battery’s charge will gradually drain, the device will 
shut down and its battery will not charge. In this 

case, disconnect the USB cable from the device, 

wake the computer from sleep mode, then 
reconnect the USB cable to the device.

 Your computer may not be supplying sufficient 

power. If you connect the device to your laptop 
computer, maintain a stable and continuous power 

supply to the laptop computer while charging the 

device.