D-Link DAS-3216_revB Software Guide

錯誤!  尚未定義樣式。 

This chapter describes GE Network uplink interface configuration. 
 
This chapter contains the following sections: 
 
z 

Configuring the GE Network Uplink Interface 

z 

Monitoring the GE Network Uplink Interface Status 

 

The ‘ethernet’ sub group contains parameter according to your GE Network uplink interface. Table 
5-1 lists the general command syntax for configuring. 
 

Use this command to create Network Ethernet parameters. 

#create ethernet intf ifname interface-name [ip ip-address] [mask net-mask] [type uplink | downlink] [enable | 
disable] 

Use this command to modify Network Ethernet parameters. 

#modify ethernet intf ifname interface-name [ip ip-address] [mask net-mask] [type uplink | downlink] [enable | 
disable] 

Use this command to get Network Ethernet parameter setting. 

#get ethernet intf [ifname interface-name] 

Use this command to delete Network Ethernet parameter setting. 

#delete ethernet intf ifname interface-name 

[ifname interface-name] 

This specifies the interface index used for the Network Ethernet. 

Type: Mandatory (Create, Modify, Delete), Optional (Get) 

Valid values: eth-1, eth-2 

[ip ip-address] 

This specifies the network IP address of given Uplink Ethernet interface, this IP address use only for 
system management. 

Type: Mandatory (Create), Optional (Modify) 

Valid values: Any valid class A/B/C address 

Default values: None 

[mask net-mask] 

This specifies the network mask configured for the interface. 

Valid values: 255.0.0.0 ~ 255.255.255.255 

[type uplink | downlink] 

This specifies the type of the Network Ethernet interfaces. The uplink is toward the Network side and 
downlink is towards the physical interface connected to the stack device.   

Type: Optional 

Valid values: uplink, downlink 

Default values: uplink 

[enable | disable] 

Administrative status of the Network Ethernet interface. 

Type: Mandatory (Modify) 

Valid values: enable, disable 

Default values: enable