KitchenAid 24-Inch 6-Cycle/7-Option Dishwasher, Pocket Handle Use & Care Manual

Page of 70
17
     
*Manufacturer's recommendation: This practice will conserve the water and energy that you would have used to prepare your dishes. 
This will also save you time and effort.
Very Hard Water
If you have hard water (above 15 grains), clean your filter at least 
once per month. Building up of white residue on your dishwasher 
indicates hard water. For tips on removing spots and stains, see 
“Troubleshooting” section.
Cleaning Instructions
IMPORTANT: Do not use wire brush, scouring pad, etc., as they 
may damage the filters.
Rinse filter under running water until most soils are removed. If you 
have hard-to-remove soils or calcium deposits from hard water, a 
soft brush may be required. 
IMPORTANT: To avoid damage to dishwasher, do not operate your 
dishwasher without the filters properly installed. Be sure the Lower 
Filter is securely in place and the Upper Filter Assembly is locked 
into place. If the Upper Filter Assembly turns freely, it is not locked 
into place.
RECOMMENDED TIME INTERVALS TO CLEAN YOUR FILTER
Number of Loads 
Per Week
If you wash 
before loading
If you scrape and rinse 
before loading
If you only scrape 
before loading*
If you do not scrape or rinse 
before loading
1-3
Once per year
Once per year
Twice per year
Every two months
4-7
Once per year
Once per year
Twice per year
Once per month
8-12
Once per year
Twice per year
Every three months
Every two weeks
13-14
Once per year
Twice per year
Every three months
Once per week
Filter Removal Instructions
1. Turn the Upper Filter 
Assembly ¼ turn 
counterclockwise 
and lift out.
2. Grasp the Lower Filter in 
the circular opening, lift 
slightly, and pull forward 
to remove.
3. Clean the filters as 
shown below.
To remove Upper Filter Assembly
L
O
C
K
UNLOC
K
PUSH DOWN &
TU
R
N
Filter Reinstallation Instructions
1. Noting the previous 
illustrations, place the 
Lower Filter under the 
Locating Tabs in the 
bottom of the dishwasher 
so the round opening for 
the Upper Filter Assembly 
lines up with the round 
opening in the bottom of 
the tub.
To replace Upper Filter Assembly
2. Insert the Upper Filter Assembly into the circular opening 
in the Lower Filter.
3. Slowly rotate the filter clockwise until it drops into place. 
Continue to rotate until the filter is locked into place. If the 
filter is not fully seated (still turns freely), continue to turn 
the filter clockwise until it drops and locks into place. 
NOTE: The Upper Filter Assembly arrow does not have to 
align with the arrow in the Lower Filter as long as the filter 
is locked.
LO
C
K
U
N
LOC
K
PUSH
DO
W
N
&
T
U
R
N