Xerox WorkCentre 5945/5955 User Guide
Copy
Xerox
®
WorkCentre
®
5945/5945i/5955/5955i
82
User Guide
Note:
If Paper Supply is set to Auto Paper Select, the Paper Conflict screen appears. Select
the desired paper tray, then select OK.
Note:
You must specify a paper tray before using this option.
9. Select
the
OK button.
10. Select any options required.
11. Enter the number of prints required using the numeric keypad on the control panel.
12. Press the Start button on the control panel to scan the original.
13. Remove the original from the document feeder or document glass when scanning has
completed. The job enters the job list ready for processing.
14. The Job Progress screen displays the progress of the current job. After the Job Progress screen
closes, press the Job Status button on the device control panel to view the job list and check
the status of the job.
the status of the job.
15. If your job remains held in the Active Jobs list, the device needs you to supply additional
resources, such as paper or staples before it can complete the job. To find out what resources
are needed, select the job and then select the Details button. Once the resources are available
the job will print.
are needed, select the job and then select the Details button. Once the resources are available
the job will print.
More Information
Reducing or Enlarging Copies by Independent X-Y %
Using a User ID to Log In at the Device
Using Internet Services to find System Administrator Contact Details
Viewing the Progress and Details of a Job using the Job Status Menu
Setting the Paper Supply for Copies
Using a User ID to Log In at the Device
Using Internet Services to find System Administrator Contact Details
Viewing the Progress and Details of a Job using the Job Status Menu
Setting the Paper Supply for Copies
Reducing or Enlarging Copies by Independent X-Y %
When you press the Start button to make a copy, the device scans your originals and temporarily
stores the images. It then prints the images based on the selections made.
stores the images. It then prints the images based on the selections made.
If Authentication or Accounting has been enabled on your device you may have to enter login
details to access the Copy features.
details to access the Copy features.
A variety of options are available on your device to enable you to reduce or enlarge the output from
your original. You can input a specific reduction or enlargement ratio, or choose from a selection of
pre-defined options.
your original. You can input a specific reduction or enlargement ratio, or choose from a selection of
pre-defined options.
The Independent X-Y% selection enables you to set different reduction or enlargement ratios for
the X (width) and the Y (length) of the image. This will produce a distorted copy of your original.
the X (width) and the Y (length) of the image. This will produce a distorted copy of your original.
1. Load your documents face up in the document feeder input tray. Adjust the guide to just touch
the documents.
Or
Lift up the document feeder. Place the document face down onto the document glass and
register it to the arrow at the top left corner. Close the document feeder.
register it to the arrow at the top left corner. Close the document feeder.
2. Press
the
Clear All button on the control panel twice, then select Confirm on the touch screen
to cancel any previous programming selections.
3. Press
the
Services Home button.
4. Select
the
Copy button on the touch screen. The copy features are displayed.
5. If required, select the Copy tab. This is usually the active tab when the Copy service opens.