Xerox DocuTech 6100 Production Publisher User Guide
Solutions in Alphabetical Order
DT6180 HandyBook 124
7. Push the Fuser Module into the machine until it stops.
To clear area 5:
8. To the left of Paper Tray 2 is a green handle with an arrow on it. Rotate the handle to the right, and
hold it in this position.
9. Remove all paper from the area to the left of Paper Tray 2.
10. Rotate the handle to the left.
To clear areas 4:
11. Grasp the green handle located in the lower left corner of the machine; approximately three inches
from the bottom.
12. Pull the handle out toward you, and up at the same time.
13. Remove all paper in the area below Paper Tray 2.
14. Pull the handle toward you, then release and lower the handle into position.
15. Close the Processor Door.
13. Remove all paper in the area below Paper Tray 2.
14. Pull the handle toward you, then release and lower the handle into position.
15. Close the Processor Door.
To clear area 2:
16. Open the right Processor Door using the handle above Paper Tray 1.
17. Lift the green handle in the lower right corner of the machine; approximately three inches from the
17. Lift the green handle in the lower right corner of the machine; approximately three inches from the
bottom.
18. Remove all paper from this area.