Xerox ColorQube 9201/9202/9203 Administrator's Guide
Network Installation
Xerox ColorQube™ 9201/9202/9203
System Administrator Guide
67
2.
Enter the Administrator’s User Name [admin], touch [Next], enter Password [1111], touch
[Enter].
[Enter].
3.
Press the <Machine Status> button, and then the [Tools] tab.
4.
Touch [Network Settings].
5.
Touch [TCP/IP Settings].
6.
Touch [Dynamic Addressing]. By default, DHCP is selected.
7.
Select the required Dynamic Addressing method:
•
BOOTP
•
DHCP
8.
Touch [Save].
9.
Touch [Close].
10. Press the <Log In/Out> button, touch [Logout] to exit Tools mode.
IPv4
Configure TCP/IP Settings using Internet Services
Note:
TCP/IP and HTTP should have been initially configured, refer to
on page 11 of this guide.
1.
At your Workstation, open the web browser and enter the IP address of the device in the Address
bar, and press [Enter].
bar, and press [Enter].
2.
Click on the [Properties] tab.
3.
If prompted, enter the Administrator User ID and Password. The default is [admin] and [1111].
4.
Click on the [Login] button.
5.
Click on the [Connectivity] link.
6.
Click on the [Protocols] link.
7.
Select [IP (Internet Protocol)] in the directory tree.
8.
Ensure that [IPv4] is selected.
9.
In the General area:
a.
The [Enabled] checkbox for Protocol will be enabled.
Note:
If the [Enabled] checkbox for Protocol is not checked, you will not be able to access Internet
Services. TCP/IP must then be enabled from the device's user interface.
CAUTION:
Disabling TCP/IP or changing the IP address will affect SLP, SNMP, NetBIOS/IP, Raw
TCP/IP Printing, SMTP, LDAP, POP3, HTTP and NTP. If TCP/IP is disabled, Internet Services will not
be available until TCP/IP is enabled from the device’s control panel. If you change the IP address,
you must reference the new address within your web browser to locate the device.
be available until TCP/IP is enabled from the device’s control panel. If you change the IP address,
you must reference the new address within your web browser to locate the device.
b.
Physical Connection will display the physical network connection. This will display
“Ethernet”.
“Ethernet”.
c.
Select one of the following method for obtaining a Dynamic IP address from the [IP Address
Resolution] drop-down menu:
Resolution] drop-down menu:
•
DHCP (Dynamic Host Configuration Protocol).