Xerox ColorQube 9201/9202/9203 User Guide
Tray 3
ColorQube™ 9201/9202/9203
Paper and Media
223
Tray 3
Tray 3 is a high capacity tray. It is intended to be the primary feeder for the most commonly used
media. This tray is permanently set as a dedicated tray and feeds only A4 or 8.5x11” LEF sized media.
The following media can be loaded in Tray 3:
media. This tray is permanently set as a dedicated tray and feeds only A4 or 8.5x11” LEF sized media.
The following media can be loaded in Tray 3:
•
Up to 2100 sheets of 75 gsm or 20 lb paper.
•
Weights from 60 to 216 gsm (16 to 56 lb).
•
Media types:
•
Bond, standard or recycled paper
•
Card
•
Pre-printed media
•
Hole punched paper
•
Carbonless paper
Tray 3 must not be used to feed labels, transparencies, envelopes or tabs. Tray 4 (Bypass Tray) can be
used for these media types.
used for these media types.
Note:
For 80 gsm paper capacities are slightly lower then specified.
Loading Tray 3
Only A4 or 8.5x11” LEF sized media can be loaded. The media size and type requested must be loaded
in the tray and the settings cannot be adjusted by the user.
in the tray and the settings cannot be adjusted by the user.
Note:
Your device does not warn you if the wrong sized media is loaded.
CAUTION:
A problem may occur if a tray is opened while it is being used to feed media.
1.
Opening the tray automatically lowers an elevator in the base of the tray.
2.
The media required is displayed on the screen. Ensure the correct media is loaded.
3.
Place the media in the tray. Media
must be positioned against the left
side of the tray.
must be positioned against the left
side of the tray.
•
Load pre-printed paper and
labels face-up and with the top
towards the front of the device.
labels face-up and with the top
towards the front of the device.
•
Load hole punched paper with
the holes on the right edge.
the holes on the right edge.
Paper must not be loaded above the
maximum fill line.
maximum fill line.
4.
Close the paper tray.
When the tray is closed the elevator rises to feed the media.