Zanussi ZRB24100XA User Manual
33
www.zanussi.com
Problem
Possible cause
Solution
Heavy build-up of frost, pos-
sibly also on the door.
Door seal is not air-tight (pos-
sibly after reversing the door).
Carefully warm the leaking sec-
tions of the door seal with a hair
dryer (on a cool setting). At the
same time shape the warmed
door seal by hand such that it sits
correctly.
Interior light does not work
Light bulb is defective.
Please look in the replacing lamp
section.
Unusual noises
Appliance is not level.
Re-adjust the feet.
The appliance is touching the
wall or other objects.
Move the appliance slightly.
A component, e.g. a pipe, on
the rear of the appliance is
touching another part of the
appliance or the wall.
It necessary, caretully move the
component out of the way.
The compressor does not
start immediately after
changing the temperature
setting.
This is normal, no error has
occurred.
The compressor will start after a
period of time.
Water on the floor or storage
shelves.
Water drain hose is blocked.
See the clean and care section.
If the malfunction shows again, contact the
Service Center.
Below data are necessary to help you quickly
Below data are necessary to help you quickly
and correctly. Write the necessary data here,
refer to the rating plate.
Model description...........................................
(Mod.)
Produkt number..............................................
(PNC)
Serial number.................................................
(S.N.)
Replacing the lamp
Model description...........................................
(Mod.)
Produkt number..............................................
(PNC)
Serial number.................................................
(S.N.)
Replacing the lamp
Caution! Before replacing the lamp,
disconnect the appliance from mains
power supply. Lamp specification: 220-
240V, max. 1,5W Follow below process
to replace the lamp:
1. Set the temperature regulation knob at
number “O” to switch off the appliance.
2. Unplug the appliance to make sure the ap-
pliance is disconnected from main power
supply.
3. Remove the screw of the lamp cover.
4. Pull the lamp cover out.
5. According to the direction showed in
4. Pull the lamp cover out.
5. According to the direction showed in
below picture,unscrew the lamp.
6. Fit new lamp according to the opposite
direction, then replace the lamp cover and
screw.
7. Plug in the appliance and regulate the
knob to the right position.
Bulb
Bulb cover
Screw
Control Box
ZANUSSI_ZRB24100WA-ZRB24100XA_CS-HU.indd 33
2016-02-16 11:00:40