Cisco Cisco TelePresence Management Suite (TMS) Version 15 Maintenance Manual
Adding systems
Cisco TMS Administrator Guide
Page 12 of 37
e. In the Directory Number Information section of
Directory Number Configuration
, select
Allow Control of Device from CTI.
f.
Set the field SSH AdminLife to 0 to prevent the CTS command-line interface password from
expiring. Cisco TMS uses this password to set up calls.
expiring. Cisco TMS uses this password to set up calls.
2. For each IP phone device that is associated to a TelePresence endpoint device, select Allow
Control of Device from CTI at the bottom of the
Device Information
section.
Preparations for adding endpoints running TE and TC software
Endpoints running TE and TC software must already have been added to the Cisco Unified CM as
detailed in the
detailed in the
For each endpoint follow these steps:
1. Go to
Device > Phone
and click the device name corresponding to the TelePresence endpoint
device.
2. At the bottom of the
Product Specific Configuration Layout
section, ensure that Web Access
and SSH Access are set to Enabled.
Adding the systems
1. In Cisco TMS, go to
Systems > Navigator
.
2. Select the folder where you want to add your Cisco Unified CM.
3. Click Add Systems.
4. Enter the IP address or DNS name of the Cisco Unified CM to add (if you want to add more than
one Cisco Unified CM, add the IP range).
5. In the Advanced Settings pane:
a. Enter Username
b. Enter Password
c.
Check the Discover Non-SNMP Systems checkbox.
6. Click Next to add the Cisco Unified CM(s). The confirmation page displays which endpoints are
registered to each Cisco Unified CM.
7. Select the folder where you want to add your endpoints.
8. Click Add Systems.
9. Select the
From List
tab.
10. Click Cisco Unified CM.
11. Select the endpoints you want to add.
12. Click Next to add the endpoints.
Adding a Cisco TelePresence Recording Server
Cisco TMS supports the addition or Cisco TelePresence Recording Servers for booking and
management purposes.
management purposes.
To add a Recording Server to Cisco TMS follow the procedures in the
Add Systems
tab
description.
Select Discover Non-SNMP Systems. Note that this will significantly increase the time required
for discovery in the
for discovery in the
Advanced Settings
pane of the tab.
Note: You need to add the Recording Server's API username and password when adding the system
to Cisco TMS.
to Cisco TMS.