Cisco Cisco Unified MeetingPlace Audio Server Installation Guide
Cisco MeetingServer 5.1 Installation Planning Guide
34
Cisco Systems
March 2003
Shielded cable must be used, and the shield must be electrically terminated
at the rear of the MeetingPlace server. MeetingPlace also supports fractional
T1 services and has complete flexibility to activate one or all ports on a
span.
at the rear of the MeetingPlace server. MeetingPlace also supports fractional
T1 services and has complete flexibility to activate one or all ports on a
span.
MeetingPlace can use dialed number information to connect the caller
directly to a meeting or to determine the MeetingPlace services to which the
caller has access.
directly to a meeting or to determine the MeetingPlace services to which the
caller has access.
MeetingPlace can also be configured to support devices where the T1 trunk
does not provide any signaling and is always offhook. This is used in
applications where a Clear Channel connection is required. (For more
information, contact your MeetingPlace support representative.)
does not provide any signaling and is always offhook. This is used in
applications where a Clear Channel connection is required. (For more
information, contact your MeetingPlace support representative.)
T1 Supported Protocols
The following are the supported protocols for T1 digital trunks.
•
T1 CAS Systems – E&M wink start, ground or loop
•
T1 PRI Systems – AT&T (TR41459, Bell (NI-2), Nortel (DMS-100)
Figure 3-5 MeetingPlace Digital Connection Requirements, T1