Cisco Cisco Unified MeetingPlace Audio Server Installation Guide

Cisco MeetingServer 5.1 Installation Planning Guide  

 

35 

 

Cisco Systems 

                                  

March 2003 

Country 

 U.S. 

Canada 

 Hong Kong 

Public Network to CSU connection 
•

 

E&M Wink Start – Line Side and Trunk Side 

•

 

Ground start or loop start – Line Side only 

(U.S. Only) 

 FCC and CSA listed CSU; channel service unit required 

Customer-supplied connectors 

 USOC (male) RJ-48 jacks. (For more 

information, see “Customer-supplied Connectors,” later in this chapter.) 

Cable provided by Latitude 

 25-foot shielded cable with ferrite  

PBX to CSU connection 

 FCC and CSA listed CSU; channel service unit 

required for connections over 600 feet. MeetingPlace comes with a 25-foot shielded 
cable with ferrite bead for each T1 span. The cable terminates in an RJ-48 connector, 
which the customer needs to interface with. Listed CSU is provided for over voltage 
protection for the T1 Smart Blade(s). 

Japan 

•

 

T1 connection into PBX with INS1500-to-T1 converter 

•

 

Latitude-supplied 15-meter shielded cable (male-male)

one per T1 span. 

Customer provides RJ45 connector. 

 

 

Australia

 

Notes:  
•

 

The FCC Part 68 registration number is EMC USA-34550-

XD-T. Be sure to use only FCC and CSA- or UL-listed channel service 
units (CSUs). 

•

 

Latitude does not supply any T1 cables with servers shipped 

to Australia. 

In some cases, the cables provided may not be appropriate for the customer’s 
PBX or NIU side connections. In this case, customers can create their own 
custom cables. Custom T1 CAS and IP cables require: 

•

 

Cat5e STP UTP cable, with shielded RJ-45 connectors terminated to the 
cable shielded at both ends 

•

 

Add the ferrite that came on the Latitude-shipped cable  

This section describes the E1 digital trunking requirements.