Cisco Cisco Unified MeetingPlace Audio Server Maintenance Manual
4-55
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8112)
OL-
Chapter 4 Configuring the 8112 Server
Configuring the system
Step 4
Enter the port numbers you want to copy to and press Enter, as shown in line 15 of
. In this
example, all ports are being configured with the same parameters as port 0, so type
1-959
and press
Enter.
Step 5
The system tells you which ports were copied to, as shown in line 16 of
.
Step 6
Type
x
and press Enter to exit the “port” utility.
Configuring spans for an E1 system
E1 spans connect to the Multi Access Blade transition modules in the back of the server.
Note
The E1 spans are automatically activated and configured with default settings when the “blade”
command is run.
command is run.
lists the default span configuration.
Check the worksheets in the MeetingPlace Audio Server 5.2 Installation and Planning Guide to see if
your system is configured this way. If these default settings are accurate for this installation, you do not
need to complete this section. If the default settings are not accurate for this installation, complete the
steps that follow.
your system is configured this way. If these default settings are accurate for this installation, you do not
need to complete this section. If the default settings are not accurate for this installation, complete the
steps that follow.
Table 4-9
Default E1 Span Configuration
Parameter
Default
Explanation
Possible Values
X
Activate the ACTI
span?
span?
y
Specifies if the span is active.
•
y = active
•
n = inactive
Framing
CRC4
Specifies the framing
protocol used on this span.
Determined by the service
provider.
protocol used on this span.
Determined by the service
provider.
We recommend using CRC4
only.
only.
•
CRC4
•
non-CRC4
Zero code
suppression
suppression
HDB3
Specifies the zero code
suppression for the span.
Determined by the service
provider.
suppression for the span.
Determined by the service
provider.
We recommend using HDB3
only.
only.
•
HDB3
Timing
external
Specifies if MeetingPlace
should get clock timing from
the PBX/Central Office or if
timing is generated by
MeetingPlace.
should get clock timing from
the PBX/Central Office or if
timing is generated by
MeetingPlace.
At least one span should
always be designated
external.
always be designated
external.
•
internal
•
external (the span
is connected to
the public
network or a
trusted system)
is connected to
the public
network or a
trusted system)