Cisco Cisco Unified MeetingPlace Audio Server Maintenance Manual
4-98
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8112)
OL-
Chapter 4 Configuring the 8112 Server
Testing the installation
Figure 4-100 activity Command — Make a Test Call
Step 4
Enter the extension of a nearby telephone as the destination phone number to be dialed. A prompt asks
if you want specific ports.
if you want specific ports.
Step 5
Enter
t
and press Enter for true. A prompt asks if you want to specify a range of ports.
Step 6
Enter
t
and press Enter for true. A prompt asks for the starting port number.
Step 7
Enter the lowest number and press Enter. A prompt asks for the ending port number.
Step 8
Enter a port number 10 or 20 ports above the starting port number and press Enter. A prompt asks if the
system should do the test calls in groups.
system should do the test calls in groups.
Step 9
Enter
f
and press Enter. A prompt asks for the delay between calls.
Step 10
Enter the desired delay and press Enter. If all is correct, the telephone rings.
Step 11
Answer the phone and listen to voice quality. Press 1 and hang up. The telnet display reports the testing
of that port is okay. The telephone is called from the next port.
of that port is okay. The telephone is called from the next port.
Step 12
Repeat the last step until all the ports in the specified group are tested.
Step 13
Repeat this procedure using the seven digit number (you may need to add a “9” along with the seven
digits if connected to a PBX) to place a call to the public network.
digits if connected to a PBX) to place a call to the public network.
Step 14
Enter
0
and press Enter to exit the “activity” command.
Troubleshooting telephony configuration
To troubleshoot the telephony testing, follow these steps.
Step 1
Check that the worksheet information was correctly entered into MeetingTime.
Step 2
Check all the physical connections to the system.
Step 3
Check that no LEDs are in a bad state. Refer to the
for an explanation of the LEDs.
meetingplace:tech$ activity
VUI Configuration: 1152 Sessions, 1200 Confs
*** VUI INTERNAL STATUS UTILITY ***
DebugMenu:
1) Quick Status of all Ports 4) Make Test Call
2) Verbose Status of Port Range 5) Show All Confs
3) Display complete Port Information 0) Quit
Enter the Command (0 -- 100): 4
You entered 4.
Enter destination for your call: