Cisco Cisco Unified MeetingPlace Audio Server Maintenance Manual
4-99
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8112)
OL-
Chapter 4 Configuring the 8112 Server
Testing the installation
Step 4
If you made any changes to the MeetingTime configuration, access the CLI and type
restart
and press
Enter.
Step 5
After the system comes back up, repeat the testing procedures.
If these actions do not correct the problem, contact the Cisco TAC.
Testing E1 telephony
To test E1 telephony connectivity, test both inbound and outbound calls.
Testing inbound calls
To verify inbound calls, you must have a means for directly selecting each of the trunks connected to
MeetingPlace. Most PBX’s and Central Office trunks either:
MeetingPlace. Most PBX’s and Central Office trunks either:
•
use circular hunting, which accesses each port in turn.
•
allow each trunk to be selected with a special dialing sequence.
When the PBX uses circular hunting
Step 1
Access the CLI. If you do not already have terminal logging turned on, turn it on before proceeding. For
information on logging, see the
information on logging, see the
Step 2
Type
spanstat <span number> -all
and press Enter. For <span number>, start with span 0 and check
each port before moving onto span 1 and other active spans.
Step 3
Dial the system access number.
Step 4
Look at the “spanstat” command output to monitor which port receives the call. For example, in
, span 0, port 1 received the call.
Figure 4-101 spanstat -all Command — E1
meetingplace:tech$ spanstat 0 -all
E1 Span 0 (ETI 0 Line A) is up
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0
10 20 30
ii........ .......... .......... .......... .......... ...........