Cisco Cisco Unified MeetingPlace Audio Server Maintenance Manual
5-22
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8112)
OL-
Chapter 5 Repairing and Maintaining the 8112 Server
Replacing the CPU
Figure 5-16 Installing the CPU Card and Transition Module
Step 2
Holding the CPU card by the ejector levers, partially insert the CPU card into the slot, about half way.
Step 3
Verify that the CPU card is properly seated in the guides on the top and bottom. If not, remove the CPU
card and try again.
card and try again.
Step 4
Pushing gently and firmly on the CPU card’s face plate, slide the CPU card into the slot until you
encounter significant resistance. At this point, the ejector levers should be in contact with the chassis
rails so they grab when pushed inward.
encounter significant resistance. At this point, the ejector levers should be in contact with the chassis
rails so they grab when pushed inward.
Step 5
Use the ejector levers to lock the CPU card in the slot by pushing the ejector levers toward one another
until they are in the locked position. See
until they are in the locked position. See
.
Step 6
Secure the CPU card by tightening the captive screws on the right and left sides of the panel. See
Step 7
Verify that any empty slots have covers on them.
Warning
An empty slot that is uncovered can result in a destructive hardware failure.
Step 8
Attach the power cable to the back of the server.
Step 9
Power up the server. Refer to the
Removing the old CPU transition module
Step 1
Verify all steps in the
have been completed.
Step 2
Locate the CPU transition module in slot 7 in the back of the server.
Step 3
With a screwdriver, loosen the CPU transition module’s captive screws at the top and bottom of the panel.
See
See
.