Cisco Cisco Unified MeetingPlace Audio Server Maintenance Manual
3-30
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8112)
OL-
Chapter 3 Installing the 8112 Server
Connecting the system cables
Figure 3-23 Back of Server (T1 PRI with 1 MA-16)
One Multi Access Blade MA-4 card
To connect the E1 or T1 PRI telephony cables for one Multi Access Blade MA-4 card, follow these steps:
Step 1
Locate the following Cisco Systems-supplied items:
•
E1 or T1 PRI telephony cables
•
breakout box (should already be mounted above the MeetingPlace server)
•
trunk card interface cable assembly (50-pin Amphenol cable)
Step 2
Plug the first E1 or T1 PRI telephony cable into the customer-supplied RJ-48c socket.
Step 3
Plug the other end of the first E1 or T1 PRI telephony cable into the slot labelled 1 on the far left of the
front of the breakout box. Continue from left to right.
front of the breakout box. Continue from left to right.
Step 4
Repeat steps 2 and 3 above until all four E1 or T1 PRI telephony cables are connected to the breakout
box.
box.
Step 5
Connect the trunk card cable assembly (50-pin Amphenol cable) to the back of the breakout box by
securing the screws on both ends. Looking at the back of the breakout box, put the 50-pin Amphenol
cable into the connector on the right.
securing the screws on both ends. Looking at the back of the breakout box, put the 50-pin Amphenol
cable into the connector on the right.
Step 6
Connect the other end of the trunk card cable assembly (50-pin Amphenol cable) into the Multi Access
Blade transition module by securing the screws on both ends. Put the 50-pin Amphenol cable into the
connector on the bottom, labeled spans 9-16.
Blade transition module by securing the screws on both ends. Put the 50-pin Amphenol cable into the
connector on the bottom, labeled spans 9-16.