Cisco Cisco Unified MeetingPlace Audio Server Maintenance Manual
4-18
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8112)
OL-
Chapter 4 Configuring the 8112 Server
Configuring the system
•
Turn the power switch to the off (“O”) position.
•
Check all connections to make sure they are secure.
•
After verifying that all components are secure, repeat the power up procedure. If MeetingPlace does
not properly initialize on the second try, contact the Cisco TAC.
not properly initialize on the second try, contact the Cisco TAC.
Step 3
At the prompt, enter your user name and password. Correct information causes
to appear.
This allows you to enter commands on the Command Line Interface (CLI). For information about CLI
commands, refer to
commands, refer to
Figure 4-19 Logging into the CLI
Configuring the system
This section describes the details for using your laptop to configure the MeetingPlace server. It covers
instructions for configuring:
instructions for configuring:
•
LAN parameters via the “net” command
•
time zone via the “timezone” command
•
T1 Smart Blades, Multi Access Blades, and Smart Blades via the “blade” command
•
date and time via the “date” command
user name: tech
Password:
Last login: Wed Oct 29 11:51:12 from lager
************************************************************
* MeetingPlace(tm) *
* by Latitude Communications *
* *
* Copyright (c) 1993-2004 Latitude Communications, Inc. *
* All rights reserved. *
************************************************************
Conference server 5.2.0 S/N: not set
Wed Oct 29 14:55:03 PST 2003
meetingplace:tech$