Cisco Cisco Unified MeetingPlace Audio Server Maintenance Manual
4-40
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8112)
OL-
Chapter 4 Configuring the 8112 Server
Configuring the system
Assigning ports to port groups
You can assign specific ports to port groups so that all ports in that group have the same parameters.
Step 1
At the tech$ prompt, type
port
.
Figure 4-45 Assigning Port Record
Step 2
Type
2
and press Enter to modify a port record. The first line in
appears.
Step 3
Type the port number and press Enter. In this example, it is port 0, so type
0
and press Enter. The rest
of
appears.
Step 4
Enter the number of the port group and press Enter. In this example, it is port group 0, so enter
0
and
press Enter.
Note
If you would like to copy this port record to other ports, refer to the
.
Step 5
Type
x
and press Enter to exit the “port” utility.
Copying port records
Copying port records provides an easy way to copy the port record for one port to as many ports as
desired. Follow these steps to do this:
desired. Follow these steps to do this:
Step 1
If you are not already accessing the “port” command, at the tech$ prompt, type
port
and press Enter.
See
.
Table 4-6
Default Protocol Table Settings — T1 PRI
Protocol
Table
Number
Table
Number
Default Protocol
2
AT&T PRI
3
Nortel PRI
4
Bell PRI
Enter port record number [0..91] : 0
------------- UNIT 0 PORT 0 --------------
--- To skip over a field, just press <cr> ---
Uses port group [ 2] :