Cisco Cisco Unified MeetingPlace Audio Server Installation Guide
Latitude Communications
MeetingPlace Audio Server Installation Planning Guide
D
Siemens HiPath 4000
configuration
configuration
When configuring the MeetingPlace 8112 or 8106 server against a Siemens
HiPath 4000 PBX system, some differences from the standard PBX
configuration are necessary. (For details about this configuration, see the next
section,
HiPath 4000 PBX system, some differences from the standard PBX
configuration are necessary. (For details about this configuration, see the next
section,
In particular, you must do the following when programming T1 trunks:
•
Program T1 trunks as TIE type trunks.
•
Program T1 trunks as EMI/Wink (not wink/immediate).
If these changes are not made, the following problems occur:
•
There is no DTMF to MeetingPlace.
•
There is no DTMF from MeetingPlace.
To confirm that DTMF exists both to and from MeetingPlace, test the outdial
by using the “activity” command.
by using the “activity” command.
Cisco setup for Siemens HiPath 4000
A printout of a Siemens HiPath 4000 configuration is shown on the next three
pages.
pages.