Cisco Cisco Unified MeetingPlace Audio Server Installation Guide
Telephony and LAN planning 3-5
February 27, 2004
Cisco MeetingPlace Audio Server Installation Planning Guide
Mounting the MeetingPlace 8112 server
The 8112 server can be mounted in either an open or closed rack or cabinet.
You must have a MeetingPlace EIA or Frame Relay rack mount kit (19-inch
or 23-inch) for this purpose.
You must have a MeetingPlace EIA or Frame Relay rack mount kit (19-inch
or 23-inch) for this purpose.
To avoid hazards arising from uneven mechanical loading of the rack, within
the limitations of equipment and cabling, plan your installation so that:
the limitations of equipment and cabling, plan your installation so that:
•
The weight of the equipment is evenly distributed in the rack
•
The heaviest units are mounted toward the bottom of the rack
For guidelines for mounting the MeetingPlace 8112 server, see the Cisco
MeetingPlace Audio Server 5.2 Customer Engineer Guide.
MeetingPlace Audio Server 5.2 Customer Engineer Guide.
Telephony planning (8112)
The following sections provide information for telephony planning for the
MeetingPlace 8112 server:
MeetingPlace 8112 server:
•
•
•
•
•
8112 60 cm of clearance
in back of the unit
in back of the unit
8106 3.8 cm of clearance
in back of the unit;
1.25 cm of clearance to
the left and right side of
the unit
in back of the unit;
1.25 cm of clearance to
the left and right side of
the unit
100 VAC (50 Hz for
East Japan; 60 Hz for
West Japan)
East Japan; 60 Hz for
West Japan)
NEMA 5-15R socket-outlet
installed within 2 meters of
the unit
installed within 2 meters of
the unit
Warning
To prevent bodily injury when mounting or servicing this unit in a rack, you
must take special precautions to ensure that the system remains stable. The
following guidelines are provided to ensure your safety:
must take special precautions to ensure that the system remains stable. The
following guidelines are provided to ensure your safety:
•
This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
•
When mounting this unit in a partially filled rack, load the rack from the bottom to the
top with the heaviest component at the bottom of the rack.
top with the heaviest component at the bottom of the rack.
•
If the rack is provided with stabilizing devices, install the stabilizers before
mounting or servicing the unit in the rack.
mounting or servicing the unit in the rack.
Statement 1006
Country
Clearance
Power
Socket
Japan