Cisco Cisco Unified MeetingPlace Audio Server Installation Guide
3-14 Telephony and LAN planning
Cisco MeetingPlace Audio Server Installation Planning Guide
February 27, 2004
The following illustration shows MeetingPlace digital connection
requirements for T1 (with 8106 server).
requirements for T1 (with 8106 server).
The following table shows the T1 telephony requirements by country.
Country
Requirements
Public Network to CSU connection
• E&M Wink Start: Line Side and Trunk Side
• Ground start or loop start: Line Side only
(U.S. Only)
:
FCC and CSA listed CSU; channel service unit required.
Customer-supplied connectors: USOC (male) RJ-48 jacks. (For more information,
see
see
)
Cable provided by Cisco: 25-foot shielded cable with ferrite.
PBX to CSU connection: FCC and CSA listed CSU; channel service unit required
for connections over 600 feet. MeetingPlace comes with a 25-foot shielded cable
with ferrite bead for each T1 span. The cable terminates in an RJ-48 connector,
which the customer needs to interface with. Listed CSU is provided for over voltage
protection for the T1 Smart Blade(s).
for connections over 600 feet. MeetingPlace comes with a 25-foot shielded cable
with ferrite bead for each T1 span. The cable terminates in an RJ-48 connector,
which the customer needs to interface with. Listed CSU is provided for over voltage
protection for the T1 Smart Blade(s).
MeetingPlace digital connection requirements, T1 (8106)
U.S.
Canada
Hong Kong