Cisco Cisco Unified MeetingPlace Audio Server Maintenance Manual
4-70
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8106)
78-16411-01
Chapter 4 Configuring the 8106 Server
Configuring the system
120 E1 ports and 120 IP ports
This section explains how to use the “blade” command when configuring 120 E1 ports and 120 IP ports.
Step 1
If you do not already have terminal logging turned on, turn it on before proceeding. For information on
logging, see the
logging, see the
Step 2
At the tech$ prompt, type
blade -e 120 -i 120
and press Enter.
Step 3
Confirm the “blade” command you entered and type
y
and press Enter. If you entered the wrong
command, type
n
and press Enter, then re-enter the correct command.
The server responds by telling you how many ports it is configuring. When the tech$ prompt appears, it
is complete. See
is complete. See
.
Figure 4-75 blade Example for 120 E1 Ports and 120 IP Ports
Step 4
Verify your configuration by typing
blade
and pressing Enter.
Step 5
.
Figure 4-76 blade Confirmation for 120 E1 and 120 IP Ports
Step 6
Type
2
and press Enter to modify a blade. A prompt for the blade slot to modify appears, as shown in
appears.
meetingplace:tech$ blade -e 120 -i 120
This will reset many DB tables, are you sure? (y/n): y
Configuring 120 E1 ports
Configuring 120 IP ports
Restart the system for changes to take effect
meetingplace:tech$
meetingplace:tech$ blade
Slot Card Type CardId Ports
1 TP1610 E1 0 0-29, 30-59, 60-89, 90-119,
2 CG6000C SB 0
3 CG6000C SB 1
4 CG6000C SB 2
5 CG6000C SB 3
6 TP1610 IP 1 120-239 (No IP address)
***** B L A D E C O N F I G M E N U *****
1) View blade details
2) Modify blade
x) Exit program