Cisco Cisco Unified MeetingPlace Audio Server Maintenance Manual
4-86
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8106)
78-16411-01
Chapter 4 Configuring the 8106 Server
Testing the installation
•
scheduling. Refer to the
.
•
conferencing. Refer to the
.
•
network latency. Refer to the
Testing T1 telephony
When testing T1 telephony connectivity, test both inbound and outbound calls.
Testing inbound calls
To verify inbound calls, you must have a means for directly selecting each of the trunks connected to
MeetingPlace. Most PBX’s and Central Office trunks either:
MeetingPlace. Most PBX’s and Central Office trunks either:
•
use circular hunting, which accesses each port in turn.
•
allow each trunk to be selected with a special dialing sequence.
When the PBX uses circular hunting
Step 1
Access the CLI. If you do not already have terminal logging turned on, turn it on before proceeding. For
information on logging, see the
information on logging, see the
Step 2
Type
spanstat <span number> -ab
and press Enter. For information about the “spanstat” command,
see the
. For <span number>, start with span 0 and check each port
before moving onto span 1 and other active spans.
Step 3
Dial the system access number.
Step 4
Look at the “spanstat” command output to monitor which port receives the call. For example, in
, span 0, port 1 received the call.
Figure 4-93 spanstat -ab Command — T1
meetingplace:tech$ spanstat 0 -ab
Span 0 (Card 0 Trunk 0) is up
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
TR TR TR TR TR TR TR TR TR TR TR TR TR TR TR TR TR TR TR TR TR TR TR TR
33 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00