Cisco Cisco Unified MeetingPlace Audio Server Maintenance Manual
4-37
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8106)
78-16411-01
Chapter 4 Configuring the 8106 Server
Configuring the system
Step 3
Type the appropriate port group record number. In this example, it is port group 0, so type
0
and press
Enter. The rest of
appears.
Step 4
Type
y
and press Enter to activate the port group.
Step 5
Type
T1
and press Enter to select the card type. Continue typing and entering the appropriate values for
the system configuration.
Step 6
Type
protocol table
and press Enter to select signaling.
Step 7
Select the appropriate protocol table number. In this example, it is protocol table 2, so type
2
and press
Enter. Refer to
for a list of default protocol tables.
•
The protocol table contains the configuration information for the type of signaling used. All T1 PRI
systems are shipped from the factory with protocol table 2 set to use the default setting of AT&T
PRI protocol, protocol table 3 to use Nortel PRI, and table 4 to use Bell PRI. If this is not correct
for your system, it can be changed via the “protparm” command. Refer to
systems are shipped from the factory with protocol table 2 set to use the default setting of AT&T
PRI protocol, protocol table 3 to use Nortel PRI, and table 4 to use Bell PRI. If this is not correct
for your system, it can be changed via the “protparm” command. Refer to
for more information on the “protparm” command.
•
If this is part of an upgrade from a pre-5.1 release, the default protocol tables 3 and 4 will not be
correct. To resolve this, use the “protparm” command to delete tables 3 and 4. This restores them to
the defaults as listed in
correct. To resolve this, use the “protparm” command to delete tables 3 and 4. This restores them to
the defaults as listed in
.
Step 8
Repeat this procedure if more than one port group is needed.
Step 9
Type
x
and press Enter to exit the “port” utility.
Assigning ports to port groups
You can assign specific ports to port groups so that all ports in that group have the same parameters.
Step 1
At the tech$ prompt, type
port
and press Enter. See
Step 2
Type
2
and press Enter to modify a port record. The first line in
appears.
Figure 4-44 Assigning Port Record
Step 3
Type the port number and press Enter. In this example, it is port 0, so type
0
and press Enter. The rest
of
appears.
Table 4-6
Default Protocol Table Settings — T1 PRI
Protocol Table Number
Default Protocol
2
AT&T PRI
3
Nortel PRI
4
Bell PRI
Enter port record number [0..91] : 0
------------- UNIT 0 PORT 0 --------------
--- To skip over a field, just press <cr> ---
Uses port group [ 2] :