Cisco Cisco Customer Voice Portal 8.0(1)
ip host tts-en-us <put IP of TTS server here>
ip host asr-en-us <put IP of ASR server here>
Important! If you are not using a TTS or ASR server you must delete the following lines from
the template you are updating:
the template you are updating:
ip host tts-en-us <put IP of TTS server here>
ip host asr-en-us <put IP of ASR server here>
ivr tts-server rtsp://tts-en-us/synthesizer
ivr asr-server rtsp://asr-en-us/recognizer
Step 5
Locate the following dial-peer definitions and replace the <IP of Cisco Communication
Manager> with the actual IP address.
Manager> with the actual IP address.
dial-peer voice 800 voip
description Send to Communication Manager--Dialpeer without CUPS
translation-profile incoming block
destination-pattern 8005557777
voice-class codec 1
session protocol sipv2
session target ipv4:<IP of Cisco Communications Manager>:5060
dtmf-relay rtp-nte h245-signal h245-alphanumeric
no vad
dial-peer voice 700 voip
description Send to Communications Manager--Dialpeer without CUPS
translation-profile incoming block
destination-pattern 7005557777
voice-class codec 1
session protocol sipv2
session target ipv4:<IP of Cisco Communications Manager>:5060
dtmf-relay rtp-nte h245-signal h245-alphanumeric
no vad
Step 6
Save your modified template file.
Copy the Configuration Changes to the Operations Console
In this task you bring the modified template into the Operations Console:
There are two ways to bring the template into the Operations Console:
•
You can copy the file to the system that is running the Operations Console, then use the Add
Template feature to browse to and add the template.
Template feature to browse to and add the template.
•
You can create a template in the Operations Console by copying an existing template, then
paste your configuration over the lines in the template copy to create a new version of the
copied template. This is the method used in the following steps.
paste your configuration over the lines in the template copy to create a new version of the
copied template. This is the method used in the following steps.
Getting Started with Cisco Unified Customer Voice Portal Release 8.0(1)
95
Chapter 10: Comprehensive Call Flow Model Exercise
Section A: Ingress Gateway/Voice Browser Configuration